Dachin AL 711
Cold spray silver

Main Composition

The coating consists of modified resin, additives, pigments, and organic solvents.

Main Characteristics

The cured film exhibits excellent adhesion, hardness, gloss, and decorative properties, along with superior weather resistance. It effectively prevents moisture and UV damage to the coating. When applied over Dachin DZ-6000 cold galvanized primer, it protects the zinc layer, enhancing corrosion resistance.

Main Applications

Designed for decorative coating on hot-dip galvanized surfaces or repair of such surfaces.

Technical Specifications

Film Color and Appearance	Silver-gray, uniform surface with no particles, pinholes, bubbles, or wrinkles
Density, kg/L	1.03±0.02
Fineness, μm	≤50
Impact Resistance, kg·cm	≥50

Package Specifications

Package Weight / kg	Package Volume / L
18	17.5

Basic Parameters

Mix Ratio	Single-component
Pot Life	Unused portions can be resealed and reused for subsequent applications.
Theoretical Consumption	Approx. 8.5㎡/L at 60μm dry film thickness

Recoat Interval

Temperature	Surface Dry	Minimum Recoat Interval	Maximum Recoat Interval
10℃	60 minutes	24 hours	Unlimited
25℃	20 minutes	12 hours
30℃	10 minutes	6 hours

Data based on standard film thickness applied to steel substrate.

Application

• Dachin AL 711 Silver Coating is recommended for application via airless spray for optimal single-coat film formation.
• Surface temperature must remain at least 3℃ above dew point with humidity <85%.
• Ensure ventilation in enclosed spaces during application.
• Thoroughly mix the coating with the hardener as required before use. Use only prepared quantities, stir thoroughly, and maintain tool cleanliness before and after application.
• Avoid contact with water, acids, or alkalis during mixing and application. Ensure the hardener container is sealed after mixing to prevent curing waste.
• Allow full curing for 7 days before putting the coated surface into service.

Compatible Coatings

Dachin DZ-6000 Cold Galvanized Primer, Dachin EP 100 Epoxy Primer, etc.

Recommended Coats

Apply 1-2 coats for a dry film thickness of 60±5μm.

Surface Preparation

Clean the substrate to remove dust and contaminants. Ensure no acid/alkali residues or moisture condensation on the surface.

Mixing

This single-component product requires only the addition of配套 diluent. Thoroughly mix with power tools before application.

Application Methods

Application Method	Diluent	Dilution Rate	Nozzle Orifice	Pressure
Airless Spraying	Dachin Thinner X13	0-10% (by paint weight)	0.4-0.5mm	10-15 MPa
Air Spraying	Dachin Thinner X13	0-10% (by paint weight)	1.5-2.0mm	0.3-0.5 MPa
Roller/Brush	Dachin Thinner X13	0-10% (by paint weight)	-	-

Dilution rates are calculated by paint weight.