Dachin HI 150
Water based nano thermal insulation coating

Product Characteristics

This is a water-based single-component high-temperature-resistant organic ceramic coating that can be directly applied to steel substrates.

Physical Characteristics

Color	White, Gray
Volume Solids	80%
Dry Film Thickness	Standard dry film thickness: 500μm
Coverage	1.4 m²/L
Density	0.60 kg/L
VOC	< 20 g/L
Shelf Life	12 months
Service Temperature	Long-term: 150℃, Short-term: 180℃
Thermal Conductivity	0.04 W/m·K
Surface Dry Time	30 minutes
Hard Dry Time	24 hours

Application Guide

Apply using airless spraying with pump compression ratio ≥33:1, nozzle size ≥3/8, pressure ≥3000 PSI. Apply one coat of 500μm, wait until surface is touch-dry, then apply the second coat. Repeat until desired thickness is achieved. Alternatively, use troweling: apply a single coat no thicker than 2mm, wait until touch-dry, then apply the second coat.

Surface Preparation

Remove all contaminants. Blast to a minimum Sa2 standard, or power tool clean to St3 standard. For small components, perform thorough degreasing and sanding with sandpaper.

Application Conditions

• Surface must be clean and above dew point temperature to prevent condensation.
• Apply at temperatures above 10℃ to ensure proper evaporation and drying of water in the coating.
• Storage and application temperatures should be above 10℃. If relative humidity exceeds 85%, ensure good ventilation to promote water evaporation and drying.
• If applied on heated surfaces, surface temperature must not exceed 80℃ to avoid blistering.

Coating Thickness

Adjust thickness based on application requirements, but this affects coverage, thinner usage, drying time, and recoat intervals. Typically apply 500μm per coat, wait until touch-dry before applying the second coat. Avoid excessive single-coat thickness to prevent blistering and other defects.

Compatibility & Recoating

For outdoor corrosion environments on steel substrates, use a temperature-resistant corrosion-resistant primer first. This coating can be applied over high-temperature primers. It can also be directly applied to non-ferrous substrates. Once fully cured, acrylic or polyurethane topcoats may be applied.

Dilution

Add 1-5% clean water and mix thoroughly before spraying.

Packaging

18 liters per drum